Show whole topic
Jan 15, 2017 7:58 pm
Jan 15, 2017 7:58 pm
Subject: Re: Chassis lubrication fitting wanted
David, are you sure that the "insert" is original ? I may be wrong, but I thought that all the restricting or metering of the flow along the pipes was done at the pump. Speaking from memory there are small adjusters under the pump to do this. I am not aware there were any other restrictors unless these were put in by someone afterwards i.e. non original. I would be interested to know the correct answer as I thought all adjustment of flow was done at the pump. I see that David Hine in his latestHandbook says..." there were 6 separate circuits and the oil flow could be adjusted to each circuit independently" (page 61).
David, are you sure that the "insert" is original ? I may be wrong, but I thought that all the restricting or metering of the flow along the pipes was done at the pump. Speaking from memory there are small adjusters under the pump to do this. I am not aware there were any other restrictors unless these were put in by someone afterwards i.e. non original. I would be interested to know the correct answer as I thought all adjustment of flow was done at the pump. I see that David Hine in his latestHandbook says..." there were 6 separate circuits and the oil flow could be adjusted to each circuit independently" (page 61).